3003 h14 aluminum sheet / 2mm / 3mm / 4mm
Back
2020-06-30 09:53
3003 h14 aluminum alloy is applicable to the unified standard of aluminum alloy strip materials. The density of 3003 h14 aluminum is very small, only 2.7 g/cm. Although it is relatively soft, it can be made into various aluminum alloys, such as hard aluminum, super hard aluminum, anti-rust aluminum, cast aluminum, etc. These aluminum alloys are widely used in manufacturing industries such as airplanes, automobiles, trains, and ships.
Mechanical properties of 3003 aluminium :
|
|
140-180 |
|
Conditional yield strength σ0.2 (MPa) |
≥115 |
|
Sample size: |
2mm, 3mm ,4mm |
|
Note: Longitudinal mechanical properties of pipe at room temperature |
|
2mm 3003 h14 aluminum sheet
2mm 3003 h14 aluminum sheet is often used in humid environments such as outer packaging, mechanical parts, refrigerators, air conditioning vent pipes, etc. This product has good anti-rust ability.
3mm 3003 h14 aluminum sheet aluminum
3mm 3003 h14 aluminum sheet aluminum is second only to silver and copper in conductivity, although its conductivity is only 2/3 of copper, but its density is only 1/3 of copper, so the same amount of electricity is delivered, and the quality of aluminum wire is only copper Half of the line. The oxide film on the aluminum surface not only has the ability of corrosion resistance, but also has a certain insulation, so aluminum has a wide range of uses in the electrical appliance manufacturing industry, wire and cable industry and radio industry.
4mm 3003 h14 aluminum sheet
The main characteristics and application scope of 4mm 3003 h14 aluminum sheet: AL-Mn series alloy, the strength of this alloy is not high (slightly higher than industrial pure aluminum), can not be strengthened by heat treatment, so cold working method is used to improve its mechanical properties: The annealed state has a high plasticity, and the plasticity is good when hardened in semi-cold work, the plasticity is low when cold-work hardened, good corrosion resistance, good weldability, and poor machinability.
Due to its good plasticity and weldability, the 3003 aluminium alloy can be used to manufacture low-load parts that hold liquids or gases, such as oil tanks, liquid containers, and other small-load parts made by deep drawing.
